Audiovox SP85 - Manual (Page 4)

TELEPHONE UNIT
FUNCTIONS
(6)
(1) IN USE
(2) NO SVC
(8) ROAM
(4) LOCK
(5) SIGNAL-
STRENGTH
(15) POWER-
(16) SPEAKER
41^ № SVC ROAM LOCK
OS.illTelNo
[0123456789
(17) MIC. JACK'
3"(6) ALPHANUMERIC
DISPLAY
(7) SEND
(8) END
(9) FUNC
.(lO)VOLUME
CONTROLS
■(ID RCL
■(12) STO
>-(13) CLK
(14) DIGIT KEYS
(1) |IN USEI indicator lights when a call is in
progress.
(2) I NO SVCl (no service) indicator lights when the
unit is in a non-coverage area.
(3) I ROAM I indicator lights when the unit is out of
the home area.
(4)
I
LOCK I indicator lights when the unit is locked.
(5) SIGNAL STRENGTH INDICATOR; The number
of shaded blocks indicates the Receiving Signal
Strength.
I t ! is also used as a POWER ON indicator
which lights when the unit is turned on.
15 CHARACTER FUNCTIONAL ALPHA­
NUMERIC DISPLAY:
First 5 characters usually indicate current
function and status conditions.
The remaining 10 characters usually show the
last 10 digits of the dialed number.
key for originating or receiving (1’) I SEND I
a call.
(8) iEN^ key terminates a call.
(9) I FUNC I (function) key shifts the digit keys to
the functional key.
(10) [V|, keys control Loudspeaker and Earpiece
audio level as well as Alert tone.
fVl: Downward, [A]: Upward
(11) I RCL I (recall) key recall telephone numbers from
memory and is also used as the FUNCTION KEY.
(12) I STO I (store) key stores number on the repertory
dialing list in memory.
(13) [CLWI (clear) key clears the digit(s) from the
memory.
(14) DIGIT KEYS to enter a telephone number.
(15)
IPOWERI switch controls power to the unit.
(16) Built-in Loudspeaker
(17) MICROPHONE JACK for HANDS-FREE
BASIC OPERATION
Turning the Unit On
With the ignition key at “ON” or “ACCESSORY”,
press the IPOWERI switch. The indicator |T) will
light (all indicator will light momentarily and will show
your telephone number, and a tone will be heard).
•Signal Strength Indicator
This enables you to know the Signal Strength in your
area. The number of the shaded blocks indicates it,
and four blocks is the maximum level. The display
will vary as your car moves. If the signal is not
strong enough to originate a call, | NO SVC I indicator
will appear on the readout.
To Store a Number in Memory
1. Press [CLR], then enter telephone number.
2. Press HO]. then enter the memory address (01
through 50).