Bernina 532-2 - Manual (Page 9)

Electrical part
I ' in . 4
12
The drive of the BEIiNINA-Eecurd Model 530-2 and Model 632-2 ia by the universal
motor placed at the rear. Motor and rheostat control are concealed beneath the protec­
tive houeinif, which bears a plate specifying the voltage and power of the motor (Fig. 4).
Prior to connecting the flex to the mains, make sure that the voltage indicated on the
plate corresponds to the mains voltage. The mains voltage is indicated on the electric
meter of your home. This must always be checked, particularly if the machine is to be
used away from home. iJo not rely on the voltage indicated on plugs and sockets.
After connecting the nod extension to the machine, start machine by exerting slight
piessiiie on the knee contiol lever with your knee. The farther the lever is displaced
to the right, the great, i the speed of the machi tie. Practise speed contiol several times
without lliieading tile maciiine.
Tile lamp is at rangeti in the swivelled head cover so that it will evenly distribute light
over the sewing area. It is switched on and off by pressing the light button. The bulb
can he cliimged when necessary; turn it anticlockwise to remove, clockwise to insert.
h ' - . iu t I ' o n t i - f l cuiincct tlic lead from tlie foot control to the machine and llien eoniieet the
main elccli ic lead. iUait machine by slight pressiiie of tlic foot on the foot control plate,
'file further the foot control plate is depressed the greater the speed of the machine.
K)