Bernina 532-2 - Manual (Page 34)

F o r t h e n e x t b u t t o n h o l e t h e x i g - z a g l e v e r l i a a t t d th e l e v e r l S / 1 5 h a v e t o 6e
a d j u s t e d a s f o l l o w s :
1. Set zig-zag lever 12a again against the stop I.
2. Turn lever 13 to the left until the w h i t e lines of the levers 13 and 12 are opposite
each other.
3. Push the stiteh length lever 16 upwards as far as it will go. Now the machine
is again adjusted for buttonhole sewing and the handling of the zig-zag lever 12a
is again effected as stated under “ t h e s te p b y step sewnip o f t h e b i i t t o u li o l e ” ,
Sawing lha buttonhola In one oparalion
In contrast to the described method, the buttonhoie can easily be sewn in one operation,
i. e. without stopping the machine after the different working steps. The buttonhole
is sewn in one operation as follows:
After having set the machine for buttonhole sewing and having pressed the zig-zag
lever 12a against the stop I (Fig. 33), start the machine and keep on holding the
zig-zag lever 12a. As soon as the desired length of bead is reached, move the zig-zag
lever 12a with a firm movement against the stop II (Fig. 38), and because only a
few stitches are necessary for stitching the fastening ends, move the zig-zag lever
12a corresponding to the sewing speed (Fig. 30) at once again to stop 1, and press it
against this stop.
As soon as the second, rtghthand bead has reached the length of the first iefthand one
except for a few stitches, move the zig-zag lever once again to stop II, and since also
only a few stitches are required for the second fastening, move the zig-zag lever
immediately quite to the right in
accordance with the sewing speed, i. e. beyond
stop I, by drawing the zig-zag lever 12a towards you, i. e, to the front.
B. Buttonhole with cord inlay
As inlay, use thin cotton cord and put it, as shown in Fig, 43, on the nose at the
back end of the buttonhole foot and sew the buttonhole in the described manner.
t is -1::
62
Ь3