Beko 4710 TBA - Manual (Page 6)

Safety precautions and important items
* The current value of the fuse in your
home shall be suitable to the current
drawn by your cooker.
* Before your appliance is connected to
the mains electricity supply, check to
ensure that the voltage and the frequency
shown in the rating label corresponds with
your power supply.
* Before applying to authorized service,
have the electrical wiring of your home
ready for connection.
* If the current value is less than 16
Amperes please have 16 A fuse with
electrician.
* The ground cable should always be
performed by the manufacturer or its
authorized service agent or a similarly
qualified person. Our company shall not
held responsible for any damage coused
by the utilisation of the oven without
ground cabling. *
* While locating your oven; do not
squeeze the supply cord under the oven
body or inside the oven door, because the
cable isolation can be damaged.
* If the supply cord is damaged, it must
be replaced by the manufacturer or its
service agent or a similarly qualified person
in order to avoid a hazard.
* In models with the timer:
Always adjust the timer during the first
operation or after any interruptions of the
electric supply. Otherwise, your oven will
not operate.
* Do not attempt to move the appliance
by pulling the door and/or handles.
* While the front door is open do not put
any heavy object on it, and do not allow
children to sit on it.
* Accessible parts of the appliance will
become very hot whilst the appliance is in
use and until the appliance has cooled.
Children should be kept away to avoid
burns and scalds.
* The packaging materials can cause
danger for the children.
* Do not forget to remove the packaging
material near the tray and wire grill, and
the polysthrene sticked to the front door
glass.
* Whilst the appliance is in use; avoid
touching heating elements inside the oven
as the accessible parts of the appliance
will become very hot.
* The appliance is not intended for use by
young children or infirm persons without
supervision.
* The cooling fan will continue for a while
after switching the oven off.
* Always switch off the appliance from
the mains when the appliance is not in
use before cleaning or in the unlikely
event of any probable product failure.
* Ensure the appliance is switched off
before replacing the lamp, to avoid the
possibility of electric shock.
* Immediately switch off the appliance
from the mains if a crack is detected on
the ceramiic glass surface, in available
models.
* In models with Grill;
*Always use oven gloves when removing
the grill rack and dishes from inside the
oven when in use.
*lf, whilst cooking, steam produced
comes into contact with cool surfaces on
the outside of the appliance, it will
condense and produce water droplets.This
is quite normal and is not a fault. Wipe it
with a dry cloth.