Lowering the heating element warning, Replacing the oven lamp, For the square-shaped lamp models – Beko 4710 TBA User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Lowering the heating element
Warning!
Make sure that the heating element is
sufficiently cool before you start cleaning.
Warning!
Never switch on the heating element or
place any wright on it when the heating
element is in the lowered position.
1. Unlock the heating elementby turning the
screw at the selling of the oven cavity.
2. After cleaning, move the heating element
upward and screw it to the ceiling of the
oven cavity.
Replacing the oven lamp:
1. Unplug the power cable.
2. Then, remove theprotective
glass cover of the lamp inside
your oven by turning it
counterclockwise.
3. Then, remove the bulb by
turning it
counter-clockwise.
4. After installing the correct
bulb obtained from an Authorized
Service, reinstall the protective glass
of the lamp.
For the square-shaped lamp models:
There are 2 square-shaped lamps
at right and left side of the oven
inside. Both lamps are on and
off at the same time.
Replacing the Oven Lamp
Disconnect
the
appliance
from the supply Take out
screws on the side shelve.
Take out Lens of the oven
lamp by means of the flat
screwdriwer. Replace defective lamp with
the new one.
Reinstall lens and side shelf. Lamp type
is 220-230V, 1 5/25W E14,T300°C
oven lamp
19