Avanti DG24CSS - Manual (Page 19)

Installation Instructions
These instaictions are intended for a qualified installer only.
Converting Gas Type
This range arrives from factory, adjusted for use with Natural Gas. The setting is
indicated on the nameplate. It is important that the range is converted, if the factory
adjusted gas type is not desired.
To avoid electric shock that can cause personal injury or death, disconnect the appliance
from the electric outlet before servicing.
> Converting Pressure Regulator
The gas pressure regulator must be set for the
type of gas being used. The inlet pressure of the
gas supply shall be in accordance with the
nominal inlet pressure of the regulator used on
the range or 1/2 psi (3.5 kPa) pressure
maximum. On the factory setting for Natural Gas
operation, the pressure regulator will regulate the
pressure to 6 inches water column pressure.
When set for LP-Propane gas operation, it will
regulate the pressure to 10 inches water column
pressure.
To change the pressure regulator setting;
• Unplug the main supply cord of the range.
• Unscrew the cap on the pressure regulator
• Lift out cap and turn it over. If set for LP-Propane gas operation, the cap
must show ”LP”. if set for Natural Gas operation, the cap must show none.
• Place the cap on pressure regulator and tighten. (See Figure 1)
Figure I
Conversion of Burner Valves
• Unplug the main supply cord of the range.
• Remove burner control knobs from range by
pulling them out.
• Remove the screws on the front surface of ^
control panel.
• Remove two screws located on the bottom
surface of control panel.
• Pull out the control panel. .
• Using a small screwdriver, loosen or tighten
the screws located on each valve. If set for
LP-Propane gas operation, the screws must
be tightened fully. In the factory setting for
Natural Gas operation, the screws must be
loosened by turning them counterclockwise
• 3/4 turn.
• Replace the control panel and screws.
• Replace the control knobs. (See Figure 2)