Troubleshooting – Ryobi 310BVr User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TROUBLESHOOTING
ENGINE WILL NOT START
C A U S E
A C T I O N
Choke in incorrect position
Refer to Starting/Stopping instructions on page 13
Empty fuei tank
Fill fuel tank with properly mixed fuel
Primer buib wasn't pressed enough
Press primer bulb fully and slowly 5-7 times until fuel
is visible in the bulb
Engine fiooded
Use starting procedure WITHOUT USING CHOKE
Oid or improperiy mixed fuei
Drain gas tank / Add fresh fuel mixture
Fouied spark piug
Replace or clean the spark plug
Plugged spark arrestor
Clean or replace spark arrestor
ENGINE WILL NOT IDLE
C A U S E
A C T I O N
Air fiiter is piugged
Replace or clean the air filter
Old or improperly mixed fuel
Drain gas tank / Add fresh fuel mixture
Improper carburetor adjustment
Adjust per instructions on page 18
ENGINE WILL NOT ACCELERATE
C A U S E
A C T I O N
Old or improperly mixed fuel
Drain gas tank / Add fresh fuel mixture
Improper carburetor adjustment
Take to an authorized service dealer for
carburetor adjustment
Throttle wire has come loose
Thread throttle wire through the carburetor throttle
lever. Tighten screw.
Dirty air filter
Clean or replace the air filter
Plugged spark arrestor
Clean or replace spark arrestor
ENGINE LACKS POWER OR STALLS
C A U S E
A C T I O N
Old or improperly mixed fuel
Drain gas tank / Add fresh fuel mixture
Air filter is plugged
Replace or clean the air filter
Improper carburetor adjustment
Take to an authorized service dealer for
carburetor adjustment
Fouled spark plug
Replace or clean the spark plug
Plugged spark arrestor
Clean or replace spark arrestor
If further assistance is required, contact your authorized service dealer.
21