How to use your tiller, Stopping (see fig. 5), Tilling – Poulan CHDF550D User Manual
Page 8: Tine operation (see fig. 5), Operation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION
The operation of any tiller can resuit ¡n foreign objects thrown into the eyes, which can
result in severe eye damage. Always wear safety glasses oi eve shields before starting
foyr tiller and while tilling, #«? recommend
n
wide vision safety mask for over spectacles
or standard safety glasses.
HOW TO USE YOUR TILLER
Know how to operate all controls before adding fuel and oil
or attempting to start engine.
STOPPING (See Fig. 5)
TINES
•
Release forward tine control to stop forward move
ment.
•
Release reverse tine control to stop reverse move
ment.
ENGINE
•
Move throttle control to “STOP” position.
•
Never use choke to stop engine.
TILLING
The speed and depth of tilling is regulated by the position
of the depth stake and wheel height.
The depth stake should always be below the wheels for
digging. It serves as a brake to slow the tiller’s forward
motion to enable the tines to penetrate the ground. Also,
the more the depth stake is lowered into the ground the
deeper the tines.wiil dig.
DEPTH STAKE (See Fig. 6)
Adjust depth stake by removing the hairpin clip and clevis
pin. Change depth stake to desired position. Replace the
clevis pin and hairpin clip.
•
For normal tilling, set depth stake at the second or third
hole from the top.
WHEELS (See Fig. 6)
Adjust wheels by removing the hairpin clip and clevis pin.
Change wheel position. Replace the hairpin clip and clevis
pin.
•
For normal tilling, setwheeisatthe second orthird hole
from the top.
TINE OPERATION (See Fig. 5)
FORWARD
•
Squeeze forward tine control to handle.
REVERSE
•
With forward tine control “OFF” (up) position, pull back
and hold reverse tine control.
8