beautypg.com

Customer responsibilities, Engine, Lubrication – Poulan CHDF550D User Manual

Page 12: Air cleaner |5ee fig. 13), Cooling system (see fig. 14)

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

CUSTOMER RESPONSIBILITIES

A

Disconnect spark plug wire before performing any maintenance (except carburetor adjustment) to prevent

accidental starting of engine.

Prevent fires! Keep the engine free of grass, leaves, spilled oil, or fuel. Remove fuel from tank before tipping
unit for maintenance. Clean muffler area of all grass, dirt, and debris.
Do not touch hot muffler or cylinder fins as contact may cause burns.

ENGINE

LUBRICATION

Use only high quality detergent oil rated with API service

classification SF, SG or SH. Select the oil’s SAE viscosity
grade according to your expected temperature.

SAE

VISCOSITY

GRADES

°F

-20"

30° 32° 40°

60°

80° 100°

°C

-30"

20°

-10° 0° 10° 20° 30° 40°

TEMPERATURE RANGE

ANTICIPATED

BEFORE

NEXT

OIL

CHANGE

FIG. 11

NOTE: Although multi-viscosity oils (5W-30,10W-30,etc.)
improve starting in cold weather, these multi-viscosity oils

will result in increased oil consumption when used above
32°F (0°C). Check your engine oil level more frequently to
avoid possible engine damage from running low on oil.

Change the oil after every 25 hours of operation or at least
once a year if the tiller is not used for 25 hours in one year.

Check the crankcase oil level before starting the engine
and after each five (5) hours of continuous use. Add SAE
30 motor oil or equivalent. Tighten oil filler plug securely
each time you check the oil level.

TO CHANGE ENGINE OIL (See Figs. 11 and 12)

Determine temperature range expected before oil change.

All oil must meet API service classification SF, SG or SH.
® Be sure tiller is on level surface.

Oil will drain more freely when warm.

• Catch oil in a suitable container.
® Remove drain plug.

Tip tiller forward to drain oil.

After oil has drained completely, replace oil drain plug
and tighten securely.

Remove oil filler plug. Be careful not to allow dirt to

enter the engine.

Refill engine with oil. See “CHECK ENGINE OIL

LEVEL” in the Operation section of this manual.

AIR CLEANER |5ee Fig. 13)

Service aircleanercartridge every twenty-five hours, more
often if engine is used in very dusty conditions.

Loosen air cleaner screws, one on each side of cover.

Remove air cleaner cover.

Carefully remove air cleaner cartridge. Be careful. Do
not allow dirt or debris to fail into carburetor.

Clean by tapping gently on a flat surface.

If very dirty or damaged, replace cartridge.

Clean and replace cover. Tighten screws securely.

A

CAUTION:

Petroleum

solvents,

such

as kerosene, are not to be

used

to clean

cartridge. They may cause deteriora­
tion of the cartridge. Do not oil car­
tridge. Do not use pressurized air to

clean or dry cartridge.

COOLING SYSTEM (See Fig. 14)

Your engine is air cooled. For proper engine performance
and long life keep your engine clean.

Clean air screen frequently using a stiff-bristled brush.

Remove blower housing and clean as necessary,

Keep cylinder fins free of dirt and chaff.

This manual is related to the following products: