NordicTrack NTE11920 - Manual (Page 8)

Locate one of the Handlebar Covers (26). Look inside
of the Handlebar Cover and locate the square tabs
connecting the two halves. Gently lift the tabs and dis­
connect the halves.
Hold the two halves of the Handlebar Cover (26)
around the tube on the left side of the Upright (2). Align
the halves and press them together until they lock.
Attach the other Handlebar Cover (26) to the right side
of the Upright (2) in the same way.
Hold the halves of the Upper Handlebar Cover (25)
around the tube on the front of the Upright (2); be
careful not to damage the Pulse Sensor Wires or
the Pulse Extension Wire (not shown). Attach the
Upper Handlebar Cover with an M4 x 12mm Screw
(96).
Have another person hold the Console (17) near the
Upright (2).
Connect the Upper Wire Harness (115) to the wire har­
ness on the Console (17). Connect the Pulse
Extension Wire (114) to the pulse wire on the Console.
Next, locate the two ground wires that are attached
with a screw to the Upright (2). Connect the ground
wires to the two smallest wires on the Console.
Carefully insert all excess wiring up into the Console
(17) and down into the Upright (2). Attach the Console
to the Upright with four 1VI4 x 16mm Screws (98).
(Note: The Screws may be shipped in the console
box.) Be careful to avoid pinching the wires.
10. Plug the Power Cord (116) into the Power Socket
(117) at the rear of the elliptical exerciser.
11. Make sure that all parts of the elliptical exerciser are properly tightened. Cover the floor beneath the
elliptical exerciser to protect the floor from damage. Note; Some extra hardware may be left over.
The elliptical exerciser is now fully assembled. If you have purchased the optional chest pulse sensor
(see page 21), refer to page 9 of this manual.