NordicTrack NTE11920 - Manual (Page 22)

MAINTENANCE AND TROUBLESHOOTING
Inspect and properly tighten all parts of the elliptical
exerciser regularly. Replace any worn parts immedi­
ately.
For smooth
operation of the
elliptical exer­
ciser, inspect
and clean the
incline ramp
regularly using
a soft cloth and
mild detergent.
Other parts of
the elliptical
exerciser can
also be cleaned in this way. Keep liquids off the
console. Never use abrasives or solvents.
HOW TO LEVEL THE ELLIPTICAL EXERCISER
If the elliptical
exerciser rocks
during use, turn
one or both of
the leveling feet
under the rear
stabilizer until
the rocking
motion is elimi­
nated.
HOW TO CALIBRATE THE INCLINE SYSTEM
If the elliptical exerciser’s incline system is not working
properly, activate the calibration process by following
the steps below.
1. Hold down the + button and the Program Select
button at the same time for about five seconds.
Note: Numbers may appear in the left and right
displays. Disregard these numbers,
2. Press the Program Select button again. Note: A
combination of letters and numbers may appear in
the displays.
3. Press the 30° Ramp button. The ramp will move all
of the way up and then all of the way down.
4. Press the Program Select button three times. The
console will then be in the normal operating mode
and the elliptical exerciser will be ready for use.
22