Poulan 2000-11 - Manual (Page 26)

ROUBLESHOOTiNG CHART
PROBLEM CAUSE CORRECTION
Viil not start • Out of fuel. • Fill fuel tank.
• Engine not “CHOKED”
properly.
• See “TO START ENGINE"
in Operation section.
• Engine flooded. • Wait several minutes
before attempting to start.
• Bad spark plug. • Replace spark plug.
• Dirty air filter. • Clean/replace air filter.
• Dirty fuel filter. • Replace fuel filter.
• Water in fuel. • Drain fuel tank and
carburetor, refill tank with
fresh gasoline and replace
fuel filter.
• Loose or damaged wiring. • Check all wiring.
• Carburetor out of adjustment. • See "fo Adjust Carburetor”
in Service Adjustments
section.
• Engine valves out of
adjustment.
• Contact an authorized
service center/department.
lard to start • Dirty air filter. • Clean/replace air filter.
• Bad spark plug. • Replace spark plug.
• Weak or dead battery. • Recharge or replace
battery.
• Dirty fuel filter. • Replace fuel filter.
• Stale or dirty fuel. • Drain fuel tank and refill
with fresh gasoline.
• Loose or damaged wiring. • Check all wiring.
• Carburetor out of adjustment. • See “To Adjust Carburetor”
in Service Adjustments
section.
• Engine valves out of
adjustment.
• Contact an authorized
service center/department.
Engine will not
urn over • Clutch/brake pedal not
depressed.
• Depress clutch/brake
pedal.
• Attachment clutch is
engaged.
• Disengage attachment
clutch.
• Weak or dead battery. • Recharge or replace
battery.
• Blown fuse. • Replace fuse.
• Corroded battery terminals. • Clean battery terminals.
• Loose or damaged wiring. • Check/replace ignition
switch.
• Faulty solenoid or starter. • Check/replace solenoid or
starter.
• Faulty operator presence
switch(es).
• Contact an authorized
service center/department.
Engine clicks but • Weak or dead battery. • Recharge or replace battery.
vill not start • Corroded battery terminals. • Clean battery terminals.
• Loose or damaged wiring. • Check all wiring.
• Faulty solenoid or starter. • Check/replace solenoid or
starter.
26