Poulan CHDR500D - Manual (Page 19)

STORAGE
Imriii-diaiely pi'erars your tiller for storage attde end of the
eeasf.i! or if the ufet wil! not Po urf.ed f.ot 30 days oi more.
A
CAUTION. Never store the tiller with
gasoline in the tank inside a building
where fumes may reach an open flame
or spark. Allow the engine to cool
before storing in any enclosure.
FILLER
» Clean entire tiller (See “CLEANING” in the Customer
Responsibilities section of this manual).
> Inspect and replace belts, if necessary (See belt re­
placement instructions in the Service and Adjustments
section of this manual).
> Lubricate as shown in the Customer Responsibilities
section of this manual.
• Be sure that all nuts, bolts and screws are securely
fastened. Inspect moving parts for damage, breakage
and wear. Replace if necessary.
■ Touch up all rusted or chipped paint surfaces; sand
lightly before painting.
ENGINE
=UEL SYSTEM
MPORTANT: IT IS IMPORTANT TO PREVENT GUM
DEPOSITS FROM FORMING IN ESSENTIAL FUEL
SYSTEM PARTS SUCH AS THE CARBURETOR, FUEL
HLTER, FUEL HOSE. OR TANK DURING STORAGE.
\LSO,
EXPERIENCE INDICATES THAT ALCOHOL
3LENDED FUELS (CALLED GASOHOL OR USING
ETHANOL OR METHANOL) CAN ATTRACT MOISTURE
VHICH LEADS TO SEPARATION AND FORMATION OF
ICIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE
"HE FUEL SYSTEM OF AN ENGINEWHILE IN STORAGE.
Drain the fuel tank.
Start the engine and let it run until the fuel lines and
carburetor are empty.
Never use engine or carburetor cleaner products in the
fuel tank or permanent damage may occur.
Use fresh fuel next season.
ЮТЕ: Fuel stabilizer is an acceptable alternative in
ninimizing the formation of fuel gum deposits during stor-
ige. Add stabilizer to gasoline in fuel tank or storage
»ntainer. Always follow the mix ratio found on stabilizer
¡ontainer. Run engine at least 10 minutes after adding
stabilizer to allow the stabilizer to reach the carburetor. Do
lot drain the gas tank and carburetor if using fuel stabilizer.
ENGINE OIL
Drain oi' (with engine warm) and replace with clean oil.
(See ‘ ENGINE” in the Customer Responsibilities section of
this manual).
.CYLINDER(S)
• Remove spark plug.
• Pour 1 ounce (29 ml) of oil through spark plug hole into
cylinder.
• Pull starter handle slowly several times to distribute oil.
• Replace with new spark plug.
OTHER
• Do not store gasoline from one season to another.
• Replace your gasoline can if your can starts to rust.
' Rust and/or dirt in your gasoline will cause problems,
• If possible, store your unit indoors and cover it to give
protection from dust and dirt.
• Cover your unit with a suitable protective cover that
does not retain moisture. Do not use plastic. Plastic
cannot breathe which allows condensation to form and
will cause your unit to rust.
IMPORTANT: NEVER COVER TILLER WHILE ENGINE
AND EXHAUST AREAS ARE STILL WARM.
19