Tine rep'lacementtsee figs. 24,25 and 26), Service and adjustments – Poulan CHDR500D User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE AND ADJUSTMENTS
■‘TiNE REP'LACEMENTtSee Figs. 24,25 and 26)
A
CAUTION:
Tines are sharp. Wear
gloves Of other protection when han
dling tines.
A
badly worn tine causes your tiller to v/ork harder and dig
more shallow. Most important, worn tines cannot chop and
shred organic matter as effectively nor bury it as deeply as
good tines. A tine this worn needs to be replaced.
To maintain the superb tilling performance of this
machine the tines should be checked for sharpness,
wear, and bending, particularly the tines which are next
to the transmission. If the gap between the tines
exceeds 3-1/2 inches (9 cm), they should be replaced
or straightened as necessary.
New tines should be assembled as shown in Fig. 26.
Sharpened tine edges will rotate rearward from above.
FIG. 25
16