Cultivating, Operation – Poulan CHDR500D User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION
CULTIVATING '
Culfivafing is destroying the weeds between rows to pre
vent them fmrn robbing nourishment and moisture from the
planis. At the same time, breaking up the upper layei ot soil
crust will help retain moistu’-e in the soil Best digging depth
is i" to 3" ( 2 - 3 - 7 3 crn). Lower the outer side shields to
protect small plants from being buried.
• Cultivate up and down the rows at a speed which will
allow tines to uproot weeds and leave the ground in
rough condition, promoting no further growth of weeds
and grass (See Fig. 15).
o 0 0 0 0
o o o 0 0
0 0 0 o o
0 0 0 0 o
V
/
f
FIG. 15
ADJUST WHEELS FOR CULTIVATING (See
Figs. 16 and 17)
•
Place blocks under right hand side of tiller and remove
hairpin clip and clevis pin from right hand wheel.
® Move wheel outward approximately 1 inch (2.5 cm)
until hole in inner wheel hub lines up with inner hole in
axle.
•
Replace clevis pin and hairpin clip on inside of wheel
and remove blocks.
•
Repeat preceding steps on left hand side.
NOTE: In extremely rough conditions and while cultivating,
the wheels should be moved outward on the axle for
increased stability.
12