Ryobi 170r - Manual (Page 9)

OPERATING PROCEDURES
CONNECTING THE CORD
1. Use an appropriate extension cord to connect to
power. See Electrical Safety Warnings for
recommended cords.
OPERATING AS A BLOWER
A
WARNING
To reduce the risk of electric shock, this unit has a
polarized plug (one blade is wider than the other).
The outdoor extension cord used with the unit
must also be polarized. The plug on the extension
cord will fit into the unit only one way. If the plug
doesn't fit fully into the unit, reverse the plug. If it
does not fit, contact a qualified electrician to install
the proper outlet. DO NOT change the plug on the
extension cord or unit in any way.
A WARNING
Wear goggles or safety glasses at all times when
operating this unit.
A
WARNING
Wear a dust mask in dusty locations.
2. Secure the extension cord to motor housing as shown
(Fig. 11).
Hold the blower as shown in Figs. 13, 14, or 15 and sweep
from side to side with the nozzle several inches above the
ground or floor. Slowly advance keeping the accumulated
pile of debris in front of you.
Most dry blowing operations are better suited to low speed
than high. Of course, you may choose to use either and
you’ll probably find the high speed is better for moving
heavier items like wet leaves or gravel.
1. Use the blower for trees, shrubs, flower beds and hard-
to-clean areas (Fig. 13).
Fig. 11
STARTING AND STOPPING THE
BLOWERA^AC
This unit is equipped with an Off/Low/High switch. For low
speed operation, slide the switch up to the first click, as
shown in Fig. 12. To select high speed, slide the switch up
to the second click, and to turn the tool ‘XDFF” slide the
switch all the way down.
Fig. 13
Fig. 12