Note, Operation – MTD 249-640A User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
NOTE
Use hydraulic sealant tape or pipe
sealant on threads.
13. Assemble the other end of forward stroke high
pressure hose to 90° pipe adapter. (Located at
rear of cylinder). See figure 11. An adjustable
wrench is required.
WARD STROKE
HOSE
90°
PIPE
ADAPTER
FIGURE 11
14. Assemble high pressure hose to pump. See figure
12. An adjustable wrench is required.
15. Assemble other end of high pressure hose to
valve. See figure 13. An adjustable wrench is
required.
FIGURE 13
OPERATION
1. Service engine with gas and oil. See'engine manual
packed with log splitter for complete instructions
for the care and maintenance of engine. READ
DIRECTIONS CAREFULLY.
A CAUTION
You must not operate log splitter
without
proper
amount
of
oil
in
reservoir tank.
FIGURE 12
Remove the breather plug from breather tube. See
figure 14. Pour 2-1/2 gallons of 10W30 H.D. oil
7 ON LY into breather tube.