MTD 249-640A - Manual (Page 6)

8. Place end of engagement rod on valve spool and
secure with hex screw (Q) and hex nut (R).
See figure 7.
FIGURE?
9. Thread pivot bushing (E) on end of engagement
rod so there is approximately 1/2" of thread
showing. Engagement handle must beat 90° to
beam. Insert pivot bushing (E) into engagement
handle. See figure 8.
PIVOT 13USHIIMG (E)
HEX NUT ID)
- 'f..
. ' hair pin
^COTTER (F)
NOTE
Engagement handle locked in reverse
position must depress valve spool to
limit.
10. Secure pivot bushing in place on engagement
rod with hex nut (D).
11. Secure the inlet hose to the pump with hose
clamp (M), provided in hardware pack. A standard
screw driver is required. See figure 9.
FIGURE 9
12. Assemble the forward stroke high pressure hose to
the valve. An adjustable wrench is required.
See figure 10.
FORWARD
STROKE
HIGH PRESSURE
HOSE
ADJUSTABL
WRENCH
i
-
FIGURES FIGURE 10