MTD 249-640A - Manual (Page 5)

ASSEMBLY INSTRUCTIONS
1. Block up rear end of log splitter so that the rear
wheels may be assembled.
2. Place spacers (C) on axle, then wheels and secure
with collars (B) and set screws (A). See figure
3.
FIGURE 3
3. Place stop bracket (P) through slot in beam. Place
engagement handle through slot in beam. See
figure 4.
4. Place stud (L) through stop bracket (P) and start
hex nut (K) on by hand. See figure 4.
5. Place end of stud through the middle hole of
engagement handle and then tighten hex nut (K).
See figure 4.
6. Secure stop bracket (P) to beam with shoulder
bolt (J). See figure 5.
FIGURE 5
7. Secure engagement handle to beam with shoulder
bolt (N) and flat washer (0). See figure 6.
ENGAGEME
HANDL
FIGURE 4 FIGURE 6