Unpacking and loose parts, Easy assembly – Troy-Bilt 12001 User Manual

Page 9

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Please follow the steps in this Section to assemble your tiller and prepare it for use. These

steps will not take long and will assure correct assembly of your new tiller. We recommend you

read this Section all the way through first. Then begin the assembly steps.

UNPACKING AND LOOSE PARTS

Your tiller was shipped fully assembled except for the parts shown in Photo 2. The small hardware

items are inside a plastic bag.

Section 2:

Easy Assembly____________

Photo 2: Contents of the shipping carton.

Compare the contents of the shipping carton

with the items shown in Photo 2. If any items

are damaged or missing, contact your local

Authorized Dealer or our Technical Service

Department for replacements or for advice on fil

ing a damage claim with the motor freight carrier.

1. The engine/tines/transmission assembly.

2. The lower left handlebar.

3. The lower right handlebar.

4. The upper handlebar.

5. The hardware bag, which contains;

a. Two curved head carriage bolts (short).

b. Six formed (curved) washers.

c. Two handlebar knobs.

d. Two hex head screws (long).

e. Two locknuts.

f. One throttle lever mounting screw.

g. One flat nut.

h. One rectangular rubber throttle lever

mounting spacer.

i. Two tie straps.

j. Two tine spacers (used when outer tines are

removed for narrow tilling).

k. One engine switch ON/OFF wire.

One engine switch.

m. Oil/fuel mixing cup.