NordicTrack NTL21905.0 User Manual

Page 9

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

5. Pivot the piston end of the Gas Spring (88) downward.

Remove the Spring Pin (102) from the end of the Gas
Spring.

Next, hold the end of the Gas Spring (88) near the indi

cated bracket on the Base (83). Press the end of the Gas
Spring as far as possible onto the ball on the bracket. If
necessary, pivot the Frame (48) slightly and rotate the
Gas Spring to align the end of the Gas Spring with the
ball on the bracket. See the inset drawing. Insert the
Spring Pin (102) into two of the small holes in the end of
the Gas Spring, and rotate the Spring Pin until it clips
onto the Gas Spring.

With the help of a second person, lower the Frame (48)
back to the floor.

6. Remove the elastic bands securing the Upright Wire

Harness (75) and the TV Cable (110). Next, insert the
Upright Wire Harness and the TV Cable through the
Handrail Spacers (95) as shown, and press the Handrail
Spacers into the tops of the Uprights (73, 74).

Have two persons hold the console assembly near the
Uprights (73, 74). Connect the Upright Wire Harness (75)

to the wire harness on the console assembly.

Make sure

to connect the connectors properly (see the inset

drawing); the connectors should slide together eas

ily and snap into place.

If the connectors do not slide

together easily and snap into place, turn one connector
and try again.

IF THE CONNECTORS ARE NOT CON

NECTED PROPERLY, THE

CONSOLE

MAY BE DAM

AGED WHEN THE POWER IS TURNED ON.

Next, connect the TV Cable (110) to the cable on the left

side of the console assembly.

Insert the Upright Wire Harness (75) and the TV Cable
(110) down into the Uprights (73, 74). Next, insert the
brackets on the console assembly into the Uprights.

careful not to pinch the wires.

Finger tighten three Handrail Bolts (64), with three
Handrail Star Washers (90), into the Right Upright (74)

and the console assembly. Repeat this step with the Left

Upright (73).

After all six Handrail Bolts have been

started, tighten the four front Handrail Bolts first,

and then tighten the other two Handrail Bolts.