MTD 94-2105-B - Manual (Page 8)

Tine Assembly
(Shipping
Position)
FiGURE 12.
FRONT
Tine Assembly
(Shipping
Position)
TINE INSTALLATION
The inner tine assemblies are installed in their correct
position at the factory. The outer tine assemblies have
been reversed for shipping purposes only. See figure
- 12 .
1. Remove both outer tine assemblies.
2. Place the left hand outer tine assembly (was
shipped on the right hand tine shaft) onto the left
hand shaft.
Clevis
Pin (C)
Hole for
28" Width
Hairpin
Clip (B)
Hole for
26" Width
3. Align one of the holes in the tine assembly with the
hole in the tine shaft. Using the end hole on the
tine assembly will give a tilling width of 28". Using
the second hole will give a tilling width of 26". See
—figure 13.
4. Secure with clevis pin (C) and hairpin clip (B).
5. Install the right hand outer tine assembly in the
same manner.
^ NOTE
Make certain tines are installed so
that the sharp edge of the tines will
enter the soil first when in forward
drive.
FIGURE 13.
Spark Plug
Wire
-V*’ Slot
\\ on Engine
FIGURE 14.
FINAL CLUTCH ADJUSTMENT
To check the forward and reverse clutch cable adjust­
ment, proceed as follows.
1. Disconnect the spark plug wire from the spark plug
to prevent accidental starting. Secure the end of
spark plug wire in the “V” slot on the engine. See
------ figure 14.
2. With both clutch grips released (neutral position),
pull the starter rope several times. The tines
should not turn. If they turn forward, loosen the
hex nut below the cable bracket on the left han­
dle a few turns. Tighten the hex nuts above the
bracket. If they turn in reverse, adjust the hex nuts
at the cable bracket on the right handle in the
same manner.