Off-season storage, Note – MTD 94-2105-B User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FIGURE 33.
3. Lift up on the idler bracket and remove the idler
pulley.
4. Unhook the reverse drive belt from the transmis
sion pulley and slide belt out.
5. Reassemble the new belt, following instructions in
reverse order.
OFF-SEASON STORAGE
If the tiller will not be used for a period longer than 30
days, the following steps should be taken to prepare
the tiller for storage.
1. Clean the exterior of engine and the entire tiller
thoroughly. Lubricate the tiller as described in the
lubrication instructions.
2. Refer to the engine section of this manual for cor
rect engine storage instructions.
3. Wipe tines with oiled rag to prevent rust.
4. Store tiller in a clean, dry area.
NOTE
When
storing
any
type of power
equipment
in
an
unventilated
or
metal storage shed, care should be
taken
to
rustproof
the
equipment.
Using a light oil or silicone, coat the
equipment,
especially
any
springs,
bearings and cables.
16