MTD 94-2105-B User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Depth Stake
Hairpin
Clip (B)
DEPTH STAKE INSTALLATION
Slide the depth stake into the tailpiece to desired depth.
Pointed end of depth stake should face forward as
■shown in figure 3. Secure with one clevis pin (C) and
hairpin clip (B).
FIGURE 3.
Lock
Brackets
HANDLE PANEL INSTALLATION
1.--- The handle mounting brackets are in an upright
position for shipping purposes. Slide the handle
panel assembly down over the handle mounting
brackets. Secure with hex bolts (D), lock washers
------ (F) and hex nuts (G). See figure 4.
FIGURE 4.
Belleville
Washer (E)
2. There are three holes in the frame, which provide
three handle height positions. Pull the handle
assembly back and select position desired, align
ing one of the holes in handle mounting bracket
—with selected hole in the frame. See figure 5, inset.
3. Place bellevilte washers (E) onto hex bolts (D)
(crowned side of washer goes against head of bolt).
Place bolts through handle mounting brackets and
frame. Secure with lock washers (F) and hex nuts
(G). See figure 5. A 9/16" wrench and an ad
justable wrench is required.
4. Tighten securely all nuts and bolts used to assem
ble the handle, including handle pivot bolts.
FIGURE 5.