Service and aojystm?>i ? s – Poulan 168191 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE AND AOjySTM?>i ? s
.f i I vfi mimm
hoosimg
Adjust the mower while tractor is parked on level ground or
r/lit SIM
.r f i i | < 1,
111
, - t o "
“PRODUCT SPECIFICATIONS” on page 3 of this manual).
ilhiv-jUu M f*i. jtillifl i u iJi if,,
Ui ll/.
''“.nr rriCiA t
' IL'F lUolDt AUjUSryLfJl (^ee Figo ¡band 17)
Raise mower to rte highest o.^!lion
• At the midpoini of both sides of mower, measure height
from bottom edge of mowerto ground. Distance “.A” on
both sides of mower should be the same or within 1/4"
of each other.
•
If adjustment is necessary, make adjustment on one
side of mower only.
» To raise one side of mower, tighten lift link adjustment
nut on that side.
•
To lower one side of mower, loosen lift link adjustment
nut on that side.
NOTE; Three full turns of adjustment nut will change
mower height about 1/8“.
•
Recheck measurements after adjusting.
e rigs.
1
o ana i a)
VEL SIDE-TO-SIDE. IF
\CK ADJUSTMENT IS
5TBOTH FRONT LINKS
TAY LEVEL SIDE-TO^
I riv ■ ! ! ) I > I ' ' I ' I I f > r . , t ( I *
IMPORTANT: DECK MUST BE LE'
THE FOLLOWING FRONT-TO-BA
NECESSARY, BE SURE TO ADJUS
EQUALLY SO MOWER Wll
' HA
i<> . '
m
M th !■< • l•IM!|ll , .It ih H
i
n'f . h Ij'liig
s i ' f H J i l l P t ' Ah
- 1 tri^.ftiii‘ 1 ip|, I, iirat^ly i/f‘to
1/'" lowM' hai. .1 ( rf r-i wh n iW ifi-wm si> i hint^-si
position.
Check t)diu''trT,tnt o,t iiohf ct
f^easurp dis-
t'jncfc ‘ D ■ directly Ml troiH a< id beriii iif ffic riir!nJiel at bottom
edge ot triuwer hou^irio w ■fn.'vu,
•
Before rriakiriq any riPi'j .-ri suiucifr.etits checHhat
both f tout links ai'joiiUoliiiSfcriyff! Boiti links should be
approxirnately 10 3/8“.
•
If links are not equal in length, adjust one link to same
length as other link.
•
To lower front of mower loosen nut “E” on both front
links an equal number of turns.
•
When distance “D” is 1/8" to 1/2" lower at front than
rear, tighten nuts “F” against trunnion on both front
links.
•
To raise front of mower, loosen nut “F” from trunnion on
both front links. Tighten nut “E” on both front links an
equal number of turns.
•
When distance “D” is 1/8" to 1/2" lower at front than
rear, tighten nut “F” against trunnion on both front links.
•
Recheck side-to-side adjustment.