Operation – Poulan 175668 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION
ADJUST WHEELS FOR CULTIVATING (See
Figs. 16 and 17)
•
Place blocks under right hand side of tiller and remove
hairpin clip and clevis pin from right hand wheel.
•
Move wheel outward approximately 1 inch {2.5 cm) until
hole in inner wheel hub lines up with inner hole in axle.
•
Replace clevis pin and hairpin clip on inside of wheel and
remove blocks.
•
Repeat preceding steps on left hand side.
NOTE; in extremely rough conditions and while cultivating,
the wheels should be moved outward on the axle for
increased stability.
11
See also other documents in the category Poulan Gardening equipment:
- PPB300 (20 pages)
- 960 41 01-39 (17 pages)
- 195806 (32 pages)
- 545212832 (14 pages)
- 530088894 (11 pages)
- 954 14 00-50 (21 pages)
- 187594 (44 pages)
- 177817 (20 pages)
- 164784 (24 pages)
- XT24H42YT (30 pages)
- 182490 (48 pages)
- 960 72 00-11 (11 pages)
- 194598 (30 pages)
- 183159 (13 pages)
- 530165403 (3 pages)
- 172782 (24 pages)
- 168301 (42 pages)
- 530164253 (16 pages)
- QCT348 (11 pages)
- 186888 (48 pages)
- 178087 (48 pages)
- PPB200 (17 pages)
- PRRT65A (28 pages)
- 189773 (24 pages)
- 183313 (48 pages)
- 545146921 (16 pages)
- 165370 (48 pages)
- 532402341 (11 pages)
- 2001-01 (24 pages)
- 197498 (30 pages)
- 184518 (48 pages)
- LTT354 (11 pages)
- 418121 (22 pages)
- 184877 (28 pages)
- 403661 (24 pages)
- 176873 (52 pages)
- 410236 (8 pages)
- 530164133 (2 pages)
- XT 532 43 91-59 (28 pages)
- 193732 (20 pages)
- DRT65 (22 pages)
- 545192166 (2 pages)
- PP036 (16 pages)
- PPB2000T (7 pages)
- HT22 (6 pages)