Ariens 924000 - Manual (Page 24)

CLUTCH LEVER
T
FASTH
^ R
/
ATTACHMENT
/ CLUTCH 0
T
◄
1
SLO w L
*' ■' 1 '
CLUTCH
LEVER
DEPRESS
FOR
WHEEL
DRIVE
78324
78400
USED ON UNITS
EQUIPPED WITH
RESISTOR SPARK PLUG
A HIGH SPEED IMPELLER ROTATES
INSIDE THIS HOUSING TO THROW
THE SNOW. NEVER REACH OR PUSH
ANY OBJECT INTO THE DISCHARGE
CHUTE WITH THE IMPELLER
ROTATING!
KEEP HANDS, FEET AND ALL
FOREIGN OBJECTS OUT OF
THE COLLECTOR (RAKES).
REPLACE SHEAR BOLTS WITH
ARIENS SHEAR BOLTS ONLY!
78329
78240
COLLECTOR
ORDER ALL DECALS BY ARIENS PART NUMBER SHOWN
INSTRUCTIONS FOR SAFE OPERATION
A
IMPORTANT
Safe Operation Practices for Snow Throwers
Training
1. Read the owner's manual carefully. Be thoroughly familiar
with the controls and the proper use of the equipment.
Know hOw to stop the unit and disengage the controls
quickly.
2. Never allow children to operate the equipment. Never allow
adults to operate the equipment without proper instruction.
3. Keep the area of operation clear of all persons, particularly
small children, and pets.
4. Exercise caution to avoid slipping or falling, especially
when operating in reverse.
Preparation .
1. Thoroughly inspect the area where the equipment is to be
used and remove all doormats, sleds, boards, wires, and
other foreign objects.
2. Disengage all clutches and shift into neutral before starting
the engine (motor).
3. Do not operate the equipment without wearing adequate
winter outer garments. VVear footwear which will improve
footing on slippery surfaces.
4. Handle fuel with care; it is highly flammable.
a. Use an approved fuel container.
b. Never add fuel to a running engine or hot engine.
c. Fill fuel tank outdoors with extreme care. Never fill fuel
tank indoors.
d. Replace gasoline cap securely and wipe up spilled fuel.
5. Use a grounded three-wire plug-in for all units with electric
drive motors or electric starting motors.
6. Adjust the collector housing height to clear gravel or
crushed rock surface.
7. Never attempt to make any adjustments while the engine
is running (except where specifically recommended by
manufacturer).
8. Let engine and machine adjust to outdoor temperatures
before starting to clear snow.
Operation
1. Do not put hands or feet near or under rotating parts. Keep
clear of the discharge opening at all times.
2. Exercise extreme caution when operating on or crossing i
gravel drives, walks, or roads. Stay alert for hidden hazards
or traffic. Do not carry passengers.
3. After striking a foreign object, stop the engir», remove the
wire from the spark plug, thoroughly inspect the snow
thrower for any damage, and repair the damage before re­
starting and operating the snow thrower.
Page 24