The set of hemmers, Darning spring – SINGER W1268 User Manual
Page 34
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

32
THE SET OF HEMMERS
Before
attaching
any
of
the
hemmers,
be
sure
bobbin
thread is pulled up. Then, with hemmer in place, hold top
thread loosely and turn handwheel one full turn toward you,
making
a
loop
under
hemmer.
Grasp
bobbin
thread
with
both hands and slip horizontally under hemmer toward back.
Bobbin thread will catch loop and carry upper thread to back
of hemmer.
Fold material in 1/8 inch for two inches along edge, hold
at each end of fold. Ship fold into guide and up over spoon.
(Fig. 43). Fold hem in material back of hemmer. Draw for
ward to end of hem and fasten with point of needle. Pull on
threads gently as you start stitching.
Fig. 43
DARNING SPRING
HOW TO ATTACH
Remove presser foot, unthread needle, place darner spring
on needle, and slip hook up over hub on needle clamp.
PATCHING AND MONOGRAMMING
See page No. 16 Fig. 24.