Binder – SINGER W1268 User Manual
Page 33
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
B I N D E R
31
This attachment folds bias binding, applies it to the edge
of material in one operation. Slots on scroll of the binder
are
for
corresponding
widths
of
commercial
folded
bias
binding.
The open mouth of binder scroll is used for unfolded bias
strips cut 15/16 inch wide.
FOLDED BINDING (Fig. 41)
Cut a point of folded binding, insert in appropriate slot.
Draw through slot and under binder with strong pin. Sliding
binder slot to right or left.
TWO-TONE BINDING (Fig. 41)
Two bindings can be sewn on fabric edge also in one
operation. When two are used, always skip one size between
widths, inserting each in correct size slot.
HAND-CUT BIAS BINDING (Fig. 42)
Cut 15/16 inch bias binding fold in half for a couple of
inches. Cut Binding diagonally toward end, almost to fold.
Slip fold into center of binder. Draw back until cut opens
and binding encircles open end of scroll. Test stitching to
be sure it is on the edge adjust if necessary.
Fig. 41
Fig. 42