Binder, Folded binding (fig. 82), Two-tone binding (fig. 82) – SINGER W951 User Manual

Page 40: Hand-cut bias binding (fig. 83), Hand-cut bias binding

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

B I N D E R

This attachment folds bias binding, applies it to the edge of material in one operation. Slots on scroll of the binder are for

corresponding widths of commercially folded bias binding.

The open mouth of binder scroll is used for unfolded bias strips cut 15/16 inch wide.

FOLDED BINDING (Fig.

82)

Cut a point on folded binding, insert in appropriate slot. Draw through

slot and under binder with strong pin. Test stitching to be sure it is on
the edge. Adjust by sliding binder to right or left.

TWO-TONE BINDING

(Fig.

82)

Two bindings can be sewn on fabric edge also in one oj^ration. When

two are used, always skip one size between widths, inserting each in
correct size slot.

HAND-CUT BIAS BINDING (Fig. 83)

Cut 15/16 inch bias binding fold in half for a couple of inches. Cut

binding diagonally toward end, almost to fold. Slip fold into center of
binder. Draw back until cut opens and binding encircles open end of
scroll. Test stitching to be sure it is on the edge adjust if necessary.

See

Fig.

and 81 for sug
gestions on how
to, use the binder.
There are hund
reds of other uses.

Fig. 82

Fig. 81

Fig. 83

-39 -