Preparing to sew, Removing the work – SINGER W951 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PREPARING TO SEW
Have take-up lever at highest point before starting to sew. Do not try to help the feeding by pulling the material
as this may deflect the needle and cause it to break.
NEVER run machine without material under presser foot.
Place material and threads in position under the presser foot and lower the presser foot. You are now ready to
begin sewing. By having the needle at its highest point, it is not necesary to touch the hand wheel to start the
machine. You merely press the control. The speed of the machine is regulated by increasing or decreasing the amount
of pressure exerted on the control.
REMOVING THE WORK
Be sure to stop the machine when
the thread take-up lever and needle bar
are at the highest position.
Now raise the presser foot and
draw the fabric back and to the left
{Fig. 17, A and B) and pass the threads
over the thread cutter.
Pull down slightly, holding thread
in both hands,
k
) as not to bend the
needle.
Leave the ends of thread under the
prefer foot.
Fig. 17A
Fig. 17B
- 11