Chapter 2. getting ready to sew, Chapter 2, Getting ready to sew – SINGER 4314 User Manual
Page 6: Choosing and changing accessories
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Chapter 2. Getting Ready to Sew
choosing and changing accessories
CHANGING THE NEEDLE
•
Raise
needle
to
its
highest
point by turning
the
hand
wheel
toward you.
Loosen
needle
clamp screw
A
and remove the needle.
•
Insert
new
needle
up
into
clamp
B
as
far
as it will go, with the flat side of the needle
to the back.
• Tighten needle clamp screw.
Flat Side to Back
CHANGING PRESSER FEET
Snap-on Presser Feet
The
presser
feet
furnished
with
your
machine
Raise
needle
to
highest
position
by
turning
the
snap on and off a common shank.
hand wheel
toward you.
Raise presser foot.
To Remove and Replace Foot
la. Press toe of presser foot upward as far as 1b. Then snap down to remove,
it will go.
2. Centre the new presser foot under the shank 3. Press presser foot screw down
firmly
until
C
and
lower the presser foot lifter
so that foot snaps into place,
the shank fits over the
presser
foot pin.