Changing needle – SINGER W1624 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CHANGING FOOT
Raise presser foot lifter.
Set needle in the highest
position by turning hand-
wheel towards you.
(DPush
lever
of
holder
towards you and foot will
come off.
(b) Position a new foot by
aligning holding groove of
shank with pin of foot.
Lower presser foot lifter
so
that
holder
catches
presser foot.
CHANGING NEEDLE
Set
the
needle
in
the
highest position by turning
the
handwheel
towards
you. Loosen needle clamp
screw and take out nee
dle. With the flat side
away from you, insert a
new needle into groove of
needle bar.
Push needle into clamp
until
it
reaches
stop
per
@
and
tighten
needle
clamp
screw
firmly.
Always
use
a
straight
needle
with
a
sharp
point.
Using defective or worn
needles not only causes
stitch skipping, breakage
of needles or snapping
of
thread;
it
also
can
damage
shuttle
and
needle plate.
Note: Always use needle
type 15x1/705
-14-