Howto change threads: tie on method – SINGER 14T970C User Manual

Page 47

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

13. HOWTO CHANGE THREADS:

TIE ON METHOD

To change thread type or color, clip thread near the

spool.

Place new thread on stand.

Tie new thread and old thread ends together with

a square knot. Clip thread taiis to 2~3cm (1 inch)

length. If clipped too short, threads may come untied.

Firmly pull both thread to test knot security.

Raise Presser foot to release Tension discs.

Pull the threads through the machine one at a time.

If threads do not pull easily, check for tangles on

thread guides or looping under thread stand.

When pulling thread through the needles, STOP
when the knot Is in front of the needle.

Cut the thread, and insert it through the needle.