Setting up the thread guide hoider, Anti-spili net, Spool cap – SINGER 14T970C User Manual

Page 11: Preparation for threading

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

7. PREPARATION FOR THREADING

Setting Up the Thread Guide Hoider

• Take out the thread guide from the top of

Styrofoam, and insert it as shown on the right

iiiustration.

• This machine is shipped with the thread guide

hoider on the top of styrofoam.

• Fuiiy extend the thread guide hoider.

• The two joints on the teiescope wili ciick into

place when they are correctiy positioned.

• Center the thread guides above the spooi pins.

• Place thread over the cone adapters on the

spool pins.

Note: Your new machine is threaded to sew

Triple Cover Stitch. Refer to Page 45 for

instructions on tying on to the threads.

Anti-spili Net

• When using synthetic threads that easily spill off

the cone, slip the anti-spill net furnished with the

machine over the thread from the bottom of the

cone leaving the thread end hanging free at the
top the anti-spill net as shown at right.

Spool Cap

• When using a regular thread spool, fit the spool

cap supplied with the machine onto the thread
spool as shown at right.