SINGER 14T970C User Manual

Page 21

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

While holding thread with fingers, pass it between the
tension discs and pull thread down to make certain it is

properly located in between the tension discs 3.

Continue to thread points 4-8.

Note: Slip thread into the rear slot on thread guides 5.

Slip the thread into the slot of the Take-up Lever
Cover 6. Slip the thread into the right slots for

thread guides 7 and 8.

Before threading eye of needle, make sure thread is

in front of thread guide located on the bottom of the
needle clamp for Cover stitch.

Thread the eye of the right needle 9.

Note: Use of tweezers in the accessory case will

make needle eye threading easy.

Draw about 10cm (4 inches) of thread through
needle eye towards the rear of the machine.

Place the thread to the back under the presser foot.