SINGER 1021 User Manual

Page 33

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

STITCH WIDTH

Two stitch width settings are required for making buttonholes: one for side
stitching and one for the bar tack. Two possible combinations are illustrated.

Selector Setting
for Bar Tack

Selector Setting

for Side Stitching

Procedure

Set stitch length in 0-1 area of stitch
length dial. Attach special purpose foot.

Set the pattern selector at | , needle
position selector at and stitch width
selector at the width desired for the side
stitching. Place work under needle, align

ing center marking of buttonhole with
center slot in the special purpose foot.

Side Stitching

Position needle In fabric at point A.
Lower foot and stitch to end of marking.
Leave needle in fabric at point B. Raise

foot and pivot work on needle. Lower

foot. Take one stitch without changing

width setting, bringing work to point C.

Bar Tack

Adjust stitch width selector for bar tacks

and take at least six stitches. Stop at point

This manual is related to the following products:

1022