SINGER 1021 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
THE BOBBIN THREAD (Continued)
Press Here
for Sewing
• Place spool of thread on spool pin.
Snap thread in the thread guide post
then lead thread around bobbin winder
tension disc, as illustrated above.
• Pass thread, from the inside, through
hole in bobbin and place bobbin on
spindle.
• push bobbin and spindle to the right
to engage the bobbin winder. Hold
thread end as shown and start the
machine, winding at moderate speed.
• Cut off thread end after a few coils
have been wound on the bobbin.
• When required amount of thread has
been wound (winding will stop when
bobbin is full), stop machine. Cut con
necting thread
• Push bobbin and spindle toward the
left to disengage bobbin winder. Re
move bobbin.
• Release hand wheel disc for sewing.
12