SINGER W3051 - Manual (Page 8)

Efts.
J№ifi
Sf^-V
£V,'
Mi
-rS\
m
4. Replace and Hemmjte
the. BaUUn. Cade.
1. Raise the presser foot by lifting the presser bar lifter.
2. Raise the needle bar to its highest point, by turning the
balance wheel toward you.
3. Open hinged slide plate to its highest point (Fig. 7f.
4. After threading the bobbin case, hold it by the latch with
its position finger opposite the notch at the top of the
shuttle race. Replace it on the center stud of the shuttle
, , ..... .... . (Fig- 8).
Fig. 7
Fig. 8
5. Then release ¡-34IC
the latch and ■ .-2-,
press the bob- (avT;-
bin case in , '
until the latch
catches the
groove near
the end of the
stud and click into potion.
6. Allow the end of the thread to hang free abo
7. Pull back slide plate.
To remove the bobbin case do all the above in
ut 2 to 3
reverse o