Sedaaihtf – SINGER W3051 User Manual

Page 19

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

17.

SedAAiHtf

ZI52AG

SU№

Fig. 23

Your Zig-Zag Sewing Machine, by virtue of its design, permits

you to do zig-zag sewing and numerous other kinds of worK

requiring a similar stitch. The controls for the zig-zag stitch

are located on the arm of the machine, as may be seen on

Fig. 23, Notice lever "B” which adjusts the width of the zig

zag seam. For ordinary straight sewing this lever must be set

to the left of marking 0 in the indicator. By moving this

lever gradually to the right toward 5 the machine will sew a

zig-zag seam of increasing width, depending on the position of

the lever. For the purpose of reverting to a previously used

width of zig-zag stitch after having done some straight sewing,

or for special types of work such as sewing buttons or making tacks, indicator A will be found useful. Thi^s

indicator serves as a

stop for dial "B”, To set indicator "A”, loosen lockscrew "D”, turning it

to the left.

You then will be able to turn same sideways which, at the same time, moves indicator TA” to the desired marking.

Tighten lockscrew "D” by turn-ing it to the right. The lockscrew also tightens slide "C”. The purpose of this

slide is to make possible a second setting of zig-zag width. Thus, when you want to alternate between a narrow

and a wide zig-zag stitch, you use both indicator "A” and slide “Ch For example, set indicator “A” at marking

4 and slide "C at

marking 1, tightening the lock screw. This will assure

you of being able to always revert

to the same narrow

and wide zig-zag seams. You will find this feature

especially convenient when making

buttonholes. Refer

to chapter on Buttonhole Sewing .