SINGER W3051 - Manual (Page 10)

6. *7b *7U^ead Um MacUine & Needle
1. Turn the balance wheel toward you to raise the needle bar
to its highest position,
2. Place a spool of thread on the spool pin.
3. Lead the thread through the arm thread-guides (Fig. 1 1 ) .
4. Run the thread down through the thread-guide to the
tension discs From right to left and up.
Then draw the thread up through the deck spring.
5. Take the thread up, through the thread guide and run the
end through the eye of the thread take-up lever from right
to left,
6. Now run the thread down through the face plate guides
and then through the loop of the needle bar guide from
the back.
7. Finally, run the end of the thread through the eye of the
needle FROM LEFT TO RIGHT, drawing it through about
3 or 4 inches.
Fig. n