SINGER 631 - Manual (Page 30)

BUTTON SKWING FOOT
Sat Lavcv at 4. The needle should then enter into
the right hole ot the button. Take approximately
six zigzag stitches in this position. End at the left
side.
To fasten stitching, adjust to number 1 Stitch
Width setting and take approximately three stitciios.
THREAD SHANK
In order to form a shank, stitching is done over
a regular machine needle. Position button and lower
button foot. Place needle in the groove of the foot
so the point enters the hole.
A larger shank results when the heavy end of
the needio is utiiiitcd.
59
a V o i? 0 9 ti » 0 o ^ o a * o » s> i t' J < s> o V -
SEAMS
ONGFRIf! SHAMS
Dainty lingerie seams are made durable! ami rij)-
proof witli zigzag stitching (Bh 2’/i), After straight
stitching the fitted seam on the wrong side, press
both seam ailowances in the same direction. Frocn
liie right side, top stitch wiiii a fine zigzag setting,
kitting llic! needle enter the seam line and then the
seam tiiickness. Particularly good evhere flat bias
scams are desired.
ITsed with the getiora! purpo.se throat plate this
foot provides a wide noodle slot which accommo­
dates all stitch settings and cais be used for most
sewing operations.
APPHICATfONS
Seams and Darts Automatic Scalloping
Mending and Maintenance Scam Ihnishes
60