SINGER 6104 - Manual (Page 13)

ihe bobbin thread!
Your sewitig machine uses two threads to form a stitch. The upper thread comes from the
spool and is thipaded through the eye of the needle. The lower thread comes from the hob-
bin. Wind fee bobbin before threading fee machine.
WINDING THE BOS&IN
Pr<^amlk>i) Steps
1. Raise the presser foot and turn hand wheel
toward you until needie is in highest po­
sition,
2. Loosen hand wheel knob A by turning it fo-
ward you With the right hand while holding
hand wheel with fee left hand.
3. Open slide plate and lift out bobbin.
4. Place spool pin felt on pin.
Winding Steps
/
• Place thread spool on spool pin with thread
retaining slit B on top. (Break paper at the
end of spool if necessary}. If you are using
a tube of thread affix spool pin extension
to spooi pin to ensure even flow of thread.
• Lead thread around bobbin winder tension
disc C and through smaii hole in bobbin
from inside out. •
• Place bobbin on spindle and push bobbin
to right to engage bobbin winder.
Hold thread end as shown and start the ma­
chine. Cut off thread end after a few coils
have been wound.
When required amount of thread has been
wound (winding will stop when bobbin is
fuil}> stop fee machine and cut connecting
thread.
Push bobbin to left and remove bobbin from
splndie.
Hold hand wheel and tighten hand wheel
knob.
I I