SINGER WS1112 - Manual (Page 7)

UPPER THREADING
Turn hand wheel toward you to raise the
take-up lever and needle to their highest position.
Place spool of thread on spool pin and lead
thread through top plate thread guide® and®.
Down and between tension discs® from right
to left.
Up and over the tension spring® then down
under the thread bar®
Up though thread bar guide® and into take-up
leverr® from right to left.
Down through thread bar guide® again and
into face plate guide® and needle clamp guide®.
Thread needle from left to right pulling three
to four inches of thread through needle.
Hold the end of the upper thread loosey and
turn hand wheel toward you until the needle goes
all the way down and comes back up bringing with
it the bottom or bobbin case thread.
Place both threads
(upper and lower)
imder the slot of the
Presser foot and place
toward the back of the
machine, leaving both
threads three to four
inches long.
Fig, 10