Sears 10062603 - Manual (Page 12)

Èiectróriic Controls:
BEFORE YOU GET STARTED____
Wheiiyó:ùr j^frigerator is iirsl" pluggeo
injhe temperature indicatorjightsv/iil ’
blink,- Press the EiiECf RONiCTEM--
PERATURE'GONTROL-of AUÀRM ■ ■ .
ClEARpad
■-;orv--:
NOTE; The alarm may go off in (2) two
hours and the High lerinp indicator iighi
Hash, if the refrigerator and freezer have
not been cooled to the proper tempera­
ture Deactivate alarm b^' pressing the
ALARM CLEAR pad.
'
r—i
POWER SWITCH
Located behind the tooighlle in the c,eriT
i ter'is-a svvúcht This switch rnust be 'jri i : '.;
the on posiiion before you.proceetl any
further.'; -' . '
START pad
To activate the control pane! first press
ELECTRONIC TEtyipERATURE CON-
:-:TROL;This wilf be: referred io as, the,;.
START pad in the remaining sections;
Pressing this pad will;
A. Turn the temperature indicator ■
lights on,
0. Àiiow you to use any of the other
pads on the control panel. If you do
not press the START pad, none of
liie pads will operate except the
ALARM CLEAR. , ■
NOTE: Once activated, the pads will
remain programmable for at least IO
minutes. .
OPTIONAL ENTRY TONE
Your refrigerator is designed to give you
the option of a ‘beep’ signal whenever a
pad IS pressed. This signanets you
know the control has ‘read' and
accepted your conTOafid. Jiie entry
signal has.beehlpre'-set Oh your control
panel and-wii'-belp!;when a pad is
pushed, if youivyish td cancel the 'beep' -
signal folios^ the-directions below
To Candel The Optiofial Entry Tone:
1, Press and hold the START pad .
(ELECTRONIC TEMPERATURE
CONTROL) approximaieiy (3) tftree to
■ (5) five seconds. Three (3) shoi t
beeps wilt sound indioallng the
instructions have been registered. To
reactivate tite entry s-gnai, repeat tiis
above process.
12