Connect shift rod, Remove tiller from crate, Tire pressure – Sears 917.299642 User Manual
Page 8: Cable clip, Adjustments, Assembly
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
CONNECT SHIFT ROD
• Insert one end of Shift Rod {Fig 6) into hole of Shift
Lever Indicator.
■ Swing Shift Rod to the right side of Tiller and insert
one of two Hairpin Clips through hole of Shift Rod
ATTACH THIS END
TO SHIFT LEVER
INDICATOR
attach
THIS END
TO SHIFT LEVER
7
SHIFT ROD
FIGURE 6
• Insert other end of Shift Rod into hole in Shift Lever
(Fig, 8)
• Insert second Hairpin Clip through hole of Shift Rod
REMOVE TILLER FROM CRATE
■ Make sure Shift Lever Indicator (Fig 7) is in “N" posi
tion.
• Till Tiller forward by lifting Handle Separate cardboard
cover from leveling shield
• Rotate Tiller Handle to the right and pull Tiller out of
Carton.
SHIFT LEVER
FIGURE 8
TIRE PRESSURE
Reduce Tire pressure to 20 PSI (Tires were overinflated
for shipping purposes) If Tire pressures are not equal,
Tiller will pull to one side
CABLE CLIP
Insert Plastic Cable Clip into hole on the back of Handle
Column Push Cables into Clip (Fig 9).
ADJUSTMENTS
Refer to Service and Adjustments Section (page 17) to
adjust Handle height
8