Sears PRO-FORM 831.297741 - Manual (Page 16)

B
if you increase the speed, the incline will automati­
cally decrease; if you decrease the speed, the in­
cline will automatically increase. If you increase the
incline, the speed will automatically decrease; if you
decrease the incline, the speed will automatically in­
crease. The console will always attempt to keep
your pulse near a predetermined setting. When the
incline reaches the highest setting, the speed can­
not be decreased any further. When the incline
reaches the lowest setting, the speed cannot be in­
creased any further.
Note: To tenminate the program before the program is
completed, press the STOP button.
Follow your progress with the five displays and
the TRAINING ZONE monitor.
See TRAINING ZONE MONITOR on pages 12 and
13.
When you are finished exercising, stop the walk­
ing belt and remove the key.
Step onto the foot rails, stop the walking belt, and re­
move the key from the console. Store the key in a
secure place. In addition, move the on/off switch to
the “off position. (See the drawing near the bottom
of page 10.)
Select the FITNESS TEST program.
FITNESS test ]
□
Press the FITNESS
TEST button. The in­
dicator beside the
button will light. Note:
if the walking belt Is
moving, it will slow to
a stop.
Enter your weight.
When the FITNESS TEST program is selected, the
letters “LbS* will flash in the CALORIES display.
You must enter your weight and age before this pro­
gram can be started. To enter your weight, see step
3 on page 11. If you have already entered your
weight, you must press one of the WEIGHT buttons
to verify the weight setting.
Enter your age.
After you have completed step 3, the letters “AGE"
will flash in the PULSE display. To enter your age,
see step 4 on page 11. If you have already entered
your age, you must press one of the AGE buttons to
verify the age setting.
Put on the pulse sensor.
The FITNESS TEST program is designed to measure
your relative fitness level. For the best results, the
FITNESS TEST should be taken at a time when your
energy level is high. The FITNESS TEST should not be
taken if you have already exercised during the day.
The FiTNESS TEST program consists of seven 4-
minute periods, and is followed by a 2-minute cool­
down period. The speed and/or incline of the treadmill
wilt automatically increase at the beginning of each 4-
minute period.
To use the FITNESS TEST program, follow the steps
below.
□ Make sure that the key Is fully Inserted Into the
console.
16
Stand on the foot rails
andhsertthekey.
Various displays and indi­
cators will tight Rnd the
dip attached to the key,
and. slide it onto the waist­
band of your clothing.
uty
The pulse sensor
must be worn when
the FITNESS TEST
program is used. To
put on the pulse sen­
sor, see HOW TO
USE THE PULSE
SENSOR on page 8. Plug the pulse sensor wire
fully into the jack on the front of the console. Note:
The FITNESS TEST program can be started without
your pulse being detected; however, the program
will automatically stop if your pulse is not detected 4
minutes after the program is started.
Press the START/PAUSE button to start the pro­
gram.
When the START/
PAUSE button is
pressed, the TIME
display will begin
counting up. The
CALORIES display
will show “LI" (level
1), indicating that the first 4-minute period of the
FITNESS TEST program has begun. The incline of
the treadmill will automatically adjust to 3.0%, and
the walking belt will begin to move at 1.5 mph. Hold
the handrails and carefully begin walking.