Sears DESTINY PLUS 204.3699969 - Manual (Page 12)

MAINTENANCE
C. REPLACING A BROKEN BELT
1. Unplug the machine.
2. Remove the Lower Base Cover (as described previously in
Removing a Blockage).
3. Lift the Brush Assembly up and out of the slots of the base
that retain the metal plates on each end of the Brush
Assembly.
4. Discard the old belt.
5. Place one end of the new belt around the motor shaft, and
the other end around the brush. Be sure the belt is not
twisted. (Figure 23) Use DESTINY® PLUS replacement belt
#71023.
6. Pull the Brush Assembly toward you, and insert the left hand
metal plate into the base slot from which it was previously
removed.
7. Insert the right hand metal plate in the right hand base slot.
(See Figure 23 for the correct positioning of the assembled
metal plates.)
8. Rotate brush by hand to check that the belt is running freely
and easily in its designated space between the bristles.
9. Re-assemble the Lower Base Cover, and refasten the two
screws. Do not over tighten.
D. REPLACING A LIGHT BULB
1. Unplug the machine.
2. Remove the Lower Base Cover Case described in the
section on Removing a Blockage.
3. Remove the burned-out bulb. Press in a new buib, and twist
into place. (Figure 24) Use DESTINY® PLUS replacement
bulb #63635.
4. Re-assemble the Lower Base Cover and refasten the two
screws. Do not over tighten.
CORRECT
POSITION FOR
METAL PLATES
10