Sears 536.884821 - Manual (Page 19)

SERVICE AND ADJUSTMENTS
TO REPLACE BELTS
The drive belts on this snow thrower are of special
construction and should be replaced with original
equipment belts available from your nearest SEARS
Store or Service Center.
You will need the assistance of a second person while
replacing the belts.
Drain the gasoline from f he fuel tank by removing the fuel
line. Drain the gas and reinstall fuel line..
CAUTION: DRAIN 1HE GASOLINE OUT
DOORS, AWAY FROM FIRE OR FLAME.
AUGER DRIVE BELT
If your snow thrower will not discharge snow, and the
auger drive belt is damaged, replace it as follows:
® Disconnect the spark plug wire.
® Remove the belt cover {See Fig, 26).
® Loosen the belt guides {See Rg. 27) and pull away
from the drive pulley.
e Loosen the auger idler pulley (See Fig 28) and slip
the belt out,
@ Remove top two bolts that secure auger housing
to motor mount frame Loosen bottom two botts.
Auger housing and motor mount frame will separate
hinged by bottom two bolls.
® Remove brake arm from housing Do not remove
spring,
© Remove the belt from the augerdrive engine pulley
m Install the original equipment replacement belt in
reverse order of removal.
® Reinstall brake arm into housing. Insure brake arm
is fully inserted into housing and brake pad is riding
in pulley groove.
« Position drive belt onto the auger drive pulley,
® Adjust Ihedftve belt (seeTo Adjust Auger Drive Bell
paragraph on page 18)
® Adjust the bell guides (see To Adjust The Beit
Guides paragraph on page 20).
® Reinstall the belt cover.
® Check clutch control cable adjustment {see page
18).
e Reconnect the spark plug wire.
THACnON DRIVE
PULLEY
BELT GUIDE
(Right Hond)
TRACTION DRIVE
IDLER PULLEY
TRACTION DRIVE BELT
BELT GUIDE
(L b H Handf
AUGER
DRIVE
BELT
AUGER DRIVE
PUUEY
AUGER IDLER
PULLEY
FIG. 27
19