Engine, Lubrication, Spark plug – Sears 536.884821 User Manual
Page 16: Engine ,16, Maintenance
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

MAINTENANCE
ENGINE
LUBRICATION
Check the crankcase oit level {See Rg. 18) before
starting the engine and after each five (5) hours of
continuous use. Add S,A, E. 10 W-30 motor oil or equ iva-
lent. Tighten fill cap/dipstick securely each time you
check the oil level. S.A .E. 5W-30 motor oil may be used
to make starting easier in areas iwhere the temperature
is 20° F or lower.
Changethe oil afterfirsi two hours of operation and every
25 hours thereafter or at least once a year if the snow
thrower is not used for 25 hours (See Fig. 19).
•
Position snow thrower so that the oil drain plug is
lowest point on the engine . Remove oil drain plug
and oit fill cap/dipstick. Drain oil into a suitable
container. Oil will drain more freely when warm
•
Replace oil drain plug and lighten securely. Refill
crankcase with S. A E,. 10W-30 motor oil (or equiva
lent). 5W-30 motor oil may be used to make
starting easier in areas where the temperature is
20° F or tower,
SPARK PLUG
•
Makesurethatthespark plug islightened securely
into the engine and the spark plug wire is attached
to the spark plug.
•
If a torque wrench is available, torque plug to 18 to
23 loot pounds.
•
Clean the area around the spark plug base before
removal to prevent dirt from entering the engine,
•
Clean the spark plug and reset the gap periodically
16